Braided Hose Fittings

Braided hose fittings is normally used to connect the different pressure of hydraulic brake hose and hose assemblies system, it is the braided stainless steel brake hose fitted with types of brake lines and braided hose crimp fittings.

Braided stainless steel hose fittings

Braided hose fittings is normally used to connect the different pressure of hydraulic brake hose and hose assemblies system, it is the braided stainless steel brake hose fitted with types of brake lines and braided hose crimp fittings.

 

The stainless steel braided hoses typically consist of a Teflon® or generic PTFE inner hose wrapped in a braid consisting of stainless steel wire with JIC fittings end.

 installing_ stainless steel braided hose fittings_install pictures

You will find:

 

Assembled braided hose fittings fit in the typical operation of a hydraulic brake system uses the premise of fluid displacement to convert operator input into friction.

 

This fluid transfer is accomplished by installing an fittings on braided hose assemblies as a connecting tube and/or hose from one hydraulic cylinder (often called the master cylinder) to another (located at the brakes of each wheel).

 

As Braided hose fittings supplier, we manufacture

braided hose compression fittings

high-temperature braided hose with fittings

Also assemble braided hose fittings on brake banjo fittings

 

we can produce all kind dimensions of braided hose fittings adapters as shape:

Straight, Elbow, Tee, Y etc, material is stainless steel, carbon steel and brass.  


We produce all stainless steel braided hose assemblies according to SAE J1401_201302, this specifies:


The performance tests and requirements for hydraulic brake hose assemblies used in the hydraulic braking system of a road vehicle.

It also specifies the methods used for identification of the hose manufacturer.

This document applies to brake hose assemblies made of a hose fabricated from yarn and natural or synthetic elastomers and assembled with metal end fittings for use with nonpetroleum-base brake fluids as specified in SAE J1703 and SAE J1705.

The nominal internal diameter of the brake hose shall fall within one of the following values: 3.5 mm or less (1/8 in or less) 4 to 5 mm (3/16 in)

 

It is the Road Vehicle--Hydraulic Brake Hose Assemblies for Use With Nonpetroleum-Base Hydraulic Fluids


Previous: Reusable Jic Hose Fittings

Next: Automotive Hose Fittings